The numbers you can assign an area go up to 65,535. Which of the following are true regarding OSPF areas?You must have separate loopback interfaces configured in each area.If your design is hierarchical, then you don't need multiple areas. You must have separate loopback interfaces configured in each area. Which of the following are true regarding OSPF areas? 1.What does router R1 use as its OSPF router-ID? Which state verifies the designated router is in the proper mode? An engineer configured an OSPF neighbor as a designated router.Which of the following network types have a designated router and a backup designated router assigned? Broadcast Point-to-pointNBMANBMA point-to-point.A router reserved these five routes from different routing information sources. If configuring a static default route on the router with the ip route 0.0.0.0 0.0.0.0 10.13.0.1 120 command, how does the router respond?Gateway of last resort is 10.12.0.1 to network 0.0.0.0O*E2 0.0.0.0/0 via 10.12.0.1, 00:00:01, GigabitEthernet0/0 10.0.0.0/8 is variably subnetted, 2 subnets, 2 masksC 10.0.0.0/24 is directly connected, GigabitEthernet0/0L 10.0.0.2/32 is directly connected, GigabitEthernet0/0C 10.13.0.0/24 is directly connected, GigabitEthernet0/1L 10.13.0.2/32 is directly connected, GigabitEthernet0/1 Which of the following network types have a designated router and a backup designated router assigned? 1.Which two of the following commands will place network 10.2.3.0/24 into area 0? 1.Which route characteristic is used by the router to forward the packet that it receives for destination IP 172.16.32.1? Router R1 is running three different routing protocols. It is an optional parameter required only if multiple OSPF processes are running on the router. It is needed to identify a unique instance of an OSPF database. Which of the following describe the process identifier that is used to run OSPF on a router? 1.Which action can you take to correct the problem in the least disruptive way? You have configured a router with an OSPF router ID, but its IP address still reflects the physical interface.What protocol is chosen by router R2 to reach the destination network 10.1 1 0/24? Router R2 is configured with multiple routes to reach network 10 1.1 0/24 from router R1. Which action must be taken in router R1 to help resolve the configuration issue? Router R1 Fa0/0 cannot ping router R3 Fa0/1. When determining the OSPF router ID, Cisco IOS selects the lowest IP address of the configured Loopback interfaces.If routers in a single area are configured with the same priority value, what value does a router use for the OSPF Router ID in the absence of a loopback interface?.What configuration error did the administrator make? You get a call from a network administrator who tells you that he typed the following into his router: Router (config) #router ospf 1 Router (config-router) #network 10.0.0.0 255.0.0.0 area 0 He tells you he still can't see any routes in the routing table.

Ipv4 loopback address